Double D Steering Shaft 24in x 3/4in ALL52175

Allstar Double D Steering Shaft 24in x 3/4in ALL52175

Solid steel shaft has the appearance of two D's stacked back to back when viewed from the end or simply a 3/4" round shaft with flats on opposite sides. Often used with stock type couplers, this shaft can be used in assemblies without welding. Commonly connected to u-joints using a set screw, the shaft should be dimple drilled to help pilot set screws and help prevent the assembly from sliding apart. ALL52132 oversized rod end is commonly used to support steering shaft. Consult sanctioning rules to verify proper installation when building a steering assembly.

 WARNING: These products may contain a chemical known to the state of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov.