Tools & Pit Equipment

Allstar -16 Steel Wrench ALL11181p>Steel twelve point AN wrenches with rubber coated handles are commonly used in tight areas such as tightening hose ends on dry sump oil pumps or fuel lines. Alternate Description -16 STEEL WRENCH Part...

Allstar -12 Steel Wrench ALL11180p>Steel twelve point AN wrenches with rubber coated handles are commonly used in tight areas such as tightening hose ends on dry sump oil pumps or fuel lines. Alternate Description -12 STEEL WRENCH Part...

Allstar -10 Steel Wrench ALL11179p>Steel twelve point AN wrenches with rubber coated handles are commonly used in tight areas such as tightening hose ends on dry sump oil pumps or fuel lines. Item Specifics Alternate Description -10 STEEL...

Allstar -8 Steel Wrench ALL11178Steel twelve point AN wrenches with rubber coated handles are commonly used in tight areas such as tightening hose ends on dry sump oil pumps or fuel lines. Alternate Description -8 STEEL WRENCH Part Number ...

Allstar Spindle Checker Chrysler Lower ALL11177 Assure correct alignment of the upper and lower ball joint when checking for bent spindles. Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent. Kits fit most aftermarket...

Allstar Spindle Checker GM Lower ALL11176 Assure correct alignment of the upper and lower ball joint when checking for bent spindles. Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent. Kits fit most aftermarket race and...

Allstar Extension Kit for 11174 ALL11175 Tool separates ball joint from the spindle. Inside of cylinder is shaped to fit over tapered stud of most ball joints and presses against stud of other ball joint. Not for use on FWD or 4WD applications. Tool is...

Allstar Ball Joint Spreader Tool ALL11174 Tool separates ball joint from the spindle. Inside of cylinder is shaped to fit over tapered stud of most ball joints and presses against stud of other ball joint. Not for use on FWD or 4WD applications. Tool is...

Allstar Taper Reamer 2.0in Per Ft. ALL11172 Repair or enlarge tapered holes to accept tie rod ends or ball joints. Reamers may be used in a drill with a 1/2" chuck by removing the T-handle. Alternate Description TAPER REAMER 2.0IN PER FT. Part...

Allstar Taper Reamer 1.5in Per Ft. ALL11170 Repair or enlarge tapered holes to accept tie rod ends or ball joints. Reamers may be used in a drill with a 1/2" chuck by removing the T-handle. Alternate Description TAPER REAMER 1.5IN PER FT. Part...

Allstar Rearend Socket QC Side Bell 1-7/8in Red ALL11161 Six-point sockets fit on a 1/2" drive ratchet to remove or install plugs on quick change rear ends. Small socket fits plugs in most center sections and side bells. Large socket fits plug in Winters...

Allstar Alum Adj Wrench 0-20AN ALL11153 Eliminate the guesswork of which wrench is needed to tighten, remove or check steel braided hose fittings. Aluminum wrenches prevent damage to fitting and are available in two sizes: 8" for fittings up to a -10,...